Frequently Asked Questions
A superb replica made by Umarex. Ruger Super Hawk 6 inch or Night Hawk. It is made almost entirely of metal, and its weight and power of output will impress even the most skeptical users.
Equipment Specifications
| Gas Type | CO2 12g |
| Firing Mode | Semi |
| Hop Up | Fixed |
| Speed | 140 - 145 m/s |
| Material | Metal, Metal |
| Recoil | With Recoil |
| Propulsion | CO2 |
| Magazine Capacity | 8 BBs |
Product Description
It's heavy, it's large, it shoots hard, and it's made by Umarex. We are obviously talking about the Ruger Super Hawk. This is the 6 inch chrome version and it manages to spark the interest and imagination of any airsoft player and beyond. Its weight, exterior finish, and operation remind us fondly of Western movies where all disputes were settled with a revolver in hand.
Umarex has tried to enhance the performance of this pistol by increasing the number of BBs that can be stored from the usual 6 to 8, integrating them into an additional plastic cylinder for support. It's not a bad idea, especially when it comes to reloading. Additionally, the price of an extra magazine is very low.
The operation mode is double action, so for each pull of the trigger, the hammer is cocked and then released. It is made almost entirely of metal except for the grip, which is covered with plastic. The pistol is equipped with a safety, and to activate it, the release button must be pulled back.
The accuracy of the pistol is very good, but the effective range is relatively short due to the lack of Hop-Up. However, pay attention to the power of the BB's output. This pistol is very powerful, with a speed of 140-145 meters per second measured with 0.20g BBs; it is very likely to be prohibited for use on most playing fields.
Power Supply
The space for storing the CO2 cartridge is in the grip, and to access it, the panels must be pulled back. With one CO2 cartridge, approximately 120 shots can be fired, making it very economical in terms of consumption. We recommend using high-quality BBs and not reusing them, as it may damage the replica.
Attention: It is recommended to spray a small amount of silicone oil on the contact seal surface before installing a new CO2 cartridge. It is not recommended to store the CO2 cartridge in the airsoft replica; after each use, even if the cartridge is not empty, it should be removed to protect the seals.