FPS Arc 100 m/s

The FPS 100 m/s spring has been calibrated for an inner barrel of 363 mm and a D-type cylinder gearbox (for internal barrels from 301 to 400 mm).

Of course, with a shorter or longer inner barrel, performance will decrease or increase, therefore calibration will be harder or softer.

The thickness of the spring guide and piston head was not taken into account during the calibration process.

So, starting from equal initial conditions, you should consider a performance increase of approximately 2.5 m/s for each bearing.

The FPS spring is 100% Made in Italy and is produced in collaboration with top companies in the sector.

The material used is polished steel wire and pre-tempered carbon steel wire with added silicon and chrome EN10270/2. In the immediate phase following formation, the spring is stabilized in an oven at a temperature of 400 degrees Celsius for thirty minutes to enhance durability.

The spring has variable pitch coils in the central area and in the area in contact with the spring guide and undergoes a grinding process on both ends which guarantees optimal performance during compression.

The product dimensions are:

- length: 170 mm

- outer diameter: 14.30 mm

It is recommended to use the spring in combination with a ball bearing spring guide and AEG piston heads for ball bearings to ensure maximum performance and durability.