Cybergun Colt 1911 GNB

Presentation:

This replica marketed by Cybergun is based on the Colt 1911 platform. Thus, the replica is equipped with all the specific elements of the 1911 platform with a design worthy of the 21st century. The replica is produced under COLT license.

Exterior of the replica:

This replica marketed by Cybergun is made almost entirely of metal. The only ABS plastic elements are the grip panels and the grip itself. The sights of the replica are fixed but well oriented. At the front of the replica, there is a standard rail that allows the mounting of devices such as lasers or flashlights.

The safeties of the replica are as follows: The trigger safety, located at the back of the grip. Thus, without a firm grip in hand, the trigger cannot be activated. There is also a hammer safety. This safety is ambidextrous and can only be used when the hammer is cocked. The pistol does not feature recoil.

Interior of the replica:

The internals of the replica are made of metal. When used under proper conditions and maintained accordingly, it is a durable replica with a low chance of malfunction. The Hop-Up is fixed. The magazine holds 15 BBs. It is recommended to use 0.20g BBs for optimal performance. The speed of the replica measured with 0.20g BBs is 100-105 meters per second.

Power:

This airsoft replica operates with 12g CO2 cartridges. The cartridge has a special compartment inside the magazine. By using CO2, the replica can be used even if the ambient temperature is lower.

Warning: It is recommended to spray a small amount of silicone oil on the contact seal surface before installing a new CO2 cartridge. It is not recommended to store the CO2 cartridge in the replica; after each use, even if the cartridge is not empty, it should be removed to protect the seals.

Periodically, the airsoft replica should be cleaned and lubricated according to the recommendations in the Service and Care section. This way, the airsoft replica can function correctly for a long time.